PolyStainer – Slide Stainer
Automating slide staining is a must for labs that wish to increase their yield. The PolyStainer performs standardized staining procedures that free lab staff from labor-intensive staining procedures. General microbiology and histology labs that seek to reduce sample staining workloads will greatly benefit from its use.
Up to 20 microscope slides are loaded in the PolyStainer basket. Next the robotic arm will dip and stir these through four exchangeable plastic wells. Slides can be dipped in a fifth drainable water well that ensures water will be renewed after rinsing each slide basket. Last, slides can be fan dried with or without heat. The four reagent wells in the system allow to perform an extremely broad array of stains.
System HighlightsWalkaway Solution:
A one push button operation triggers the entire staining procedure.Unique Design:
The PolyStainer was uniquely designed to separate its staining area from the system’s electronics and mechanics, this ensures endurance due to separation from highly oxidative reagents.Staining Protocol Optimization:
Ensures no cross contamination by using the PolyStainer’s rinsing well drain to keep rinsing water clean. Speeds stain preparation by drying out slides.
|Slides / Basket||20 slides each basket|
|Basket Lifting Motor||2.6W 12V /c 141:1 /encoder|
|Carriage Movement Motor||1.65W 12V / 28:1 / encoder|
|Heater||12ºC-15ºC higher that the room temperature|
|Heater Air Pressure||80 Pa|
|Air Volume||30 m3/h|
|Water Control||Electro valve 4W 24V IP65|
|Water Flow Program||Permanent/Autoiniciated at previous bath|
|Water Pressure||2bar / 6bar (instrument supplied with three different manifold)|
|Basket Holder||Stainless Steel AISI 304|
|Basket||Stainless Steel AISI 304|
|Additional connections for peripherals||2 x USB Host ports|
|Programming Memory||10 programs – 10 steps per program|